Course Kits

Introduction Kit –

  • Arduino-Compatible Uno R3
  • Breadboard – 400 holes (5.5 x 8.5 cm)
  • USB A-male to B-male
  • 1 x N4078-2C Relay (5V )
  • 9 x 5mm Colour LED’s (Red, Green, Yellow)
  • 1 x NPN transistor (P2N2222A)
  • 1 x Triple Output RGB LED
  • 2 x 5mm Micro-switches/Tactile
  • 1 x LDR (Photocell)
  • 1 x 74HC595 Shift Register
  • 1 x Ultrasonic Sensor (HC-SR04)
  • 1 x Potentiometer/rotary pot – 10K
  • 1 x 1N4004 Diode
  • 10 x 220 ohm resistors
  • 10 x 10kohm resistors
  • 10 x 1k ohm resistors
  • 10 x 4,7k ohm resistors
  • Dupont Breadboard Jumper Cable Wire Kit (APPROX 65 pcs, Male to Male)
  • 1 x Plastic Component Box

 

Starter Kit

Intermediate Kit for practical project (Intermediate Course) –

  • 1602 LCD Keypad Shield (HD44780-Control)
  • DS1307 Time RTC Module I2C
  • SD Card Module
  • BMP085 – Barometric Pressure Sensor
  • DHT11 – Temperature and Humidity Sensor
  • Prototype cable (male-female) – for connecting modules to breadboard
  • Breadboard – 400 holes (5.5 x 8.5 cm) – extending breadboard size from Introduction Kit
  • 4 Gig SD card

Note: Kit was upgraded from a single LCD display to a LCD Keypad Shield

Cost : R550